ASUS P4P800-E RAID CONTROLLER DRIVER

The settings for RAID for the built into the main chipset drive controller are in the mboard’s bios Setup. This is about as good as it gets and if you read it, you will most likely be able to set up what you want to: Thus the bios can “see” the drives. The issue is either you didn’t use the setup utility to assign drives or raid or there is an issue with the drives physically or electrically in it’s attachment to the raid array. Net is the opinions of its users.

Uploader: Zulull
Date Added: 11 August 2004
File Size: 58.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4595
Price: Free* [*Free Regsitration Required]

Thats is WinXP see’s the array and all the data is there and it works fine. But when I boot the machine I see the same situation as the old post. To make sure they install properly go to device managed and uninstall the old FastTrak driver, reboot and when new hardware is found point to your downloaded driver there was no need to cut to disc Hope this helps.

P4PE Deluxe | ASUS Global

I remember Clintfan explained how to set up non raid sata drives on the promise controller on a P4P E. The information on Computing.

  MINOLTA MS3000 DRIVER

Support for accessing the Fastrak’s bios’s RAID configuration utility is built into the mboard’s bios version. The settings for RAID for the built into the main chipset drive controller are in the mboard’s bios Setup.

Use Question Form such as ” Why? If you don’t respond to that within x 5?

The conclusion of the expert in the old post was that the drives were dead. Net and its accuracy. Net is the opinions of its users.

The Promise controller is the Fastrak controller. Current Temperatures Take II. Would you use Snapchat filters on your dog? Originally Posted by blackduck Remove Advertisements Sponsored Links. Windows 7 Ultimate x All times are GMT You should have seen a hot key sequence before this or maybe after that says something to enter raid config.

Suspicious Activity Detected

If the Promise Fastrak controller is enabled in the mboard’s bios settings it probably is by defaultwhen you boot the computer you always see this first: Net cannot verify the validity of the statements made on this site. What else could I try? BB code is on. If at least one daid is detected connected to the Promise Fastrak controller and is are being detected correctly, you’ll see a line pp4800-e indicates the drive s has have been detected, and if at least two drives or possibly at least one is are detected, then THAT’S when you’ll see the line that tells you what keys to press to access it’s RAID utility Ctrl-F in this case?

  6910P BLUETOOTH DRIVER

Virus Problem, Please Help. There’s no need to load the Fastrak’s bios if no drives are detected connected to the controller.

Windows claims the Promise drivers are installed there is a trick but I cannot remember!! Thousands of contrpller waiting to help! I doubt the message no bios installed is correct for diag use.

I will upload the exact options later if you need them. If you want the operating system to be on the RAID array Thus the bios controler “see” the drives. The old post was: The issue is either you didn’t use the setup utility to assign drives or raid or there is an issue with the drives physically or electrically in it’s attachment to the raid array.